ASSESSMENT AND HAZARDS IDENTIFICATION ANALYSIS RISK CONTROL IN WELDING WORKSHOP SMK NEGERI 2 PEKANBARU
Keywords:Hazard Identification, Risk Assessment, Risk Control
Hazard identification is a stage that can provide comprehensive and detailed information about the risks found by explaining the consequences of the lightest to the most severe. The purpose of this study was to determine the danger, assessment and control of risk in the Welding Workshop of SMK Negeri 2 Pekanbaru. The type and design used in this study were descriptive qualitative research with an observational approach with 4 informants. The results of the study were 13 cases that had the potential to cause danger with a high risk level of 7 cases with a percentage of 54%, moderate risk level of 2 cases with a percentage of 15%, a low risk level of 4 cases with a percentage of 31%.
Isafety Magazine. 2018.Safety Health and Environment: 2018 National K3 Report to Welcome the December 2018 Edition of K3 Month. Safety Development Foundation.
Ministry of Education and Culture. 2016. Grand Design Development of Teaching Factory and Technopark in SMK. Central Jakarta: Ministry of Education and Culture.
Murdiyono. 2016. "Hazard Identification, Assessment and Risk Control in Welding Workshop at SMK N 2 Pengasih". Faculty of Engineering. Yogyakarta State University.
OHSAS. 18001: 2007. Occupational Health and Safety Management System Requirements, ICS 03.100.01; 13.100.
Ramli, Soehatman. (2010). OHSAS 18001 Occupational Health & Safety Management System. Jakarta: Dian Rakyat
Tarwaka, 2014. Occupational Safety and Health, Management and Implementation of K3 in the Workplace, Harapan Press, Surakarta.